Waiting for my 36mm fan clutch wrench to arrive...so while I wait I am going to replace the purge solenoid (if I can find it) and then start on cutting and polishing the exterior.

 

Thanks for the tip!

 

Spent a few hours clay baring, cutting, and polishing "Tricky Dick" Not too bad for 16 year old truck

And Replaced Purge Solenoid

 

I changed out my water pump on my Disco 2. Everything went smooth. I found a water pump on eBay with a 10 year warranty for $32.00.

 

Got my rhino tire cover today

 

Got the lift done on my 02. 3" TF kit from lucky8. Rides better now that the shocks aren't blown out, which surprised me since it's HD springs. Doesn't feel very tall when driving, although people sure look now! Before measurement was ~820mm all around except the front left which had a broken spring. Now sits at ~895mm after driving for about 200km.

 

Scored a voyager challenge edition and 4 hella 4000s and went wheeling. Pics soon.

 

Not gonna spam you guys with too many pics but here's three!

 

 

It's been a while, but I finally installed my Lucky8 front drive shaft, new plugs and wires and brake rotors and pads all around. Now just need to get to the O2 sensors and MAF.