does the hub on a 99 disco ii need to be pressed on or can i gently whack it back onto the spline?

 

It's a unit bearing I think and it shouldn't need to be pressed on.

 

it is a unit just a liitle concerned ..im at that point about to go get a puller on sat night and dont wanna get stuck first one ..

 

oh yeah and i tore up a puller but not a thrree jaw

 

Clean and lube the splines before reassembly. Use the axle nut to pull the axle into the hub/ bearing assy once you have the splines lined up.

For the unit bearing, pull that into the knuckle by using the mounting bolts, gradually tightening in a star pattern until fully seated.

 

im done thank you for the reply the three jaw works great

 

okay so any input would be appreciated ......
replaced the left side hub still and its still making the noise.
it makes a noise that goes away when i turn right and some time at high sppeds. sounds like (wow wow wow wow) .... any ideas are appreciated