traction control
Thread Starter
|
1st Gear
Joined: Feb 2023
Posts: 1
Likes: 0
traction control
I was stuck in the snow traction control system did work properly in a Land Rover Discovery 4, 3 wheels spinning and slipping one wheel not spinning normally brake should be applied on the spinning wheel so the power goes to the wheel which is not spinning ( two front wheel and right rear wheel spinning). I do have increased revs it didn't work if anybody can explain why thanks .there is a film on youtube that shows discovery find immediately in all modes where the power should go and the wheel with traction begins to spin. I presume that there is a bug in the software in some
initial condition onboard computer can not detect that one wheel is not spinning.it is very strange that a car can detect and transfer the power to the
wheel with traction immediately almost *film on youtube. Sometimes you should increase the revs as a lot of people experience. and sometimes it is not working in my experience
initial condition onboard computer can not detect that one wheel is not spinning.it is very strange that a car can detect and transfer the power to the
wheel with traction immediately almost *film on youtube. Sometimes you should increase the revs as a lot of people experience. and sometimes it is not working in my experience
Thread
Thread Starter
Forum
Replies
Last Post