I recently acquired a GAP IID tool, and replaced my back left height sensor, I am now calibrating the ride height, but I cannot seem to find what height it is supposed to ride at. The technical manuals have you using a a specific length rod for calibration, but I cannot find a measurement from say the center of the wheel to the bottom of the fender trim. Any assistance would be greatly appreciated

 

I might have answered my own question. In the manual under lower control arm install there is a step where you jacked the control arm up till the center of the hub was 18.34" from the fender trim for front and 19.10" for back. Can anyone confirm this is correct for ride height?

 

It's listed in the Gap IID manual, but the numbers are 466mm for the front (center of wheel to bottom of wheel arch) and 485mm for the rear.