EPB electrical problem after changing rear pads
Thread Starter
|
6th Gear
Joined: Nov 2023
Posts: 6
Likes: 0
From: South Bend IN
EPB electrical problem after changing rear pads
I recently changed my rear pads (I did not fully remove the entire caliper). I did not put it into brake service mode.
I thought all was okay due to nothing being out of the ordinary on my first drive.
Since then the Brake light has been on and the Emergency brake light is flashing. My GAP tool shows an error code of U2002-92
I tried changing the EPB switch which made no difference and wondering where to start next. The Parking brake is not locked on and when in neutral it rolls freely. I heard no rubbing or noise as i am driving.
Where should i look next?
I thought all was okay due to nothing being out of the ordinary on my first drive.
Since then the Brake light has been on and the Emergency brake light is flashing. My GAP tool shows an error code of U2002-92
I tried changing the EPB switch which made no difference and wondering where to start next. The Parking brake is not locked on and when in neutral it rolls freely. I heard no rubbing or noise as i am driving.
Where should i look next?
Thread
Thread Starter
Forum
Replies
Last Post
