reluctantly I decided to do headgaskets on daily driver disco, upon completing pax side found driver Cyl 3 needs resleaved.leak between block and sleeve. Lots of good parts or fix and use. Open to parting out if get enough interest but needs to still roll and look like a truck. It's been a good work truck not destroyed but not prestine

227k I've put 100k of those miles on it
new fuel pump less than 5k ago
new rear bearing less than 5k ago
factory brake pads less than 5k ago
all idler pulleys less than 5k ago
alternator 2-3 years ago battery about same time
factory hitch and trailer wiring (Land Rover kit not antermarket)
have d1 wiper blade kit never installed (make offer)
se7 have other seat just not installed ( needed cargo space)
rear ac
big cup holder kit
owners manual
have Thule cross bars will sell for 80$ been installed maybe 2 months hauled 1 ladder

bad front bumper
dented drivers door
front windscreen crack along bottom does not affect driving/ vision
trans mode switch broken ( dog stepped on it)
rear sunroof needs cables/ leaks
3 amigos not reset after wheel bearing change

parts or whole just thought I'd offer it up to enthusiasts first, currently drivers head is off and in garage pics to be uploaded shortly they are on my phone.

Location dayton Ohio and sorry I have no way to transport at present as the rover was my tow vehicle

Phone 248 495 2856 txt is best ( quickest response)
or message back here or e mail
defiantnx01@aol.com

it is listed locally basically want gone or part out for close to 800 then will call the hook to get it

Dog not included