If there's anyone out there converting from SLS to springs, I'd love to buy all your SLS material, assuming it works. I'm looking to swap my coils to SLS, but it's on a truck that never had SLS to begin with. Basically looking for the dash switch, air bags, ride heigh sensors, compressor, tubing and the filter from behind the driver's side taillight.

 

I have some items, compressor tubing, dash switch, etc. I don’t know if the compressor works but it looks clean.

 

Oh cool! How much do you think everything would clock in at?

 

Let me pull it all and make sure I can remove it without breaking anything. Have you found directions to install this? There should be a pigtail of wires under the drivers side passenger door where the shelf is attached to the frame rail to plug in the compressor. I think it’s 3 connectors.

 

I have a set of Arnott bags with only a couple thousand miles on them if you end up needing a set. I had reinstalled the sls on my disco and then removed it again because I preferred the springs.