couple question on 300tdi conversion
#14
some info for you guys! pedal box swapped right in without disturbing the brake lines too much. don't try to put crossmember and transmission in at the same time. take the studs out of bottom of the mounts to get them lined up without squishing or stretching the mounts. don't forget the little clip that goes on the tob fork before you put the engine and trans together.
mine is in and sounds great! however a few problems I can't quite figure out.
temp gauge is not doing anything. tried grounding it and a few other wires and nothing happens at all. still using v8 cluster if that matters
fuel gauge is going crazy saying i have 3/4 a tank when i put 2 gallons of diesel in. i used silver creek motors method
speedometer does nothing
and need to figure out how to wire reverse lights.
any help is appreciated!
mine is in and sounds great! however a few problems I can't quite figure out.
temp gauge is not doing anything. tried grounding it and a few other wires and nothing happens at all. still using v8 cluster if that matters
fuel gauge is going crazy saying i have 3/4 a tank when i put 2 gallons of diesel in. i used silver creek motors method
speedometer does nothing
and need to figure out how to wire reverse lights.
any help is appreciated!
#15
temp gauge is not doing anything. tried grounding it and a few other wires and nothing happens at all. still using v8 cluster if that matters
fuel gauge is going crazy saying i have 3/4 a tank when i put 2 gallons of diesel in. i used silver creek motors method
speedometer does nothing
any help is appreciated!
fuel gauge is going crazy saying i have 3/4 a tank when i put 2 gallons of diesel in. i used silver creek motors method
speedometer does nothing
any help is appreciated!
I'll look at my wiring for the speedo and see if there was a jump or bypass because of the ECU/non EDC fuel pump - I didn't want the fly-by-wire pump.
#16
i have not. anyway to test the sender? i could also have the wrong wire. there are two green w/blk wires coming from the bulkhead switches and i thought i saw somewhere it could be green w/blue.
thanks!
i may not even bother with this temp sender. came across the correct part numbers for vdo gauge and sender
310-105 2 1/16 250F Elec. engine temp gauge Vision
323-095 Temperature Sender: 250F/120C - 1/8-27 NPT
50 bucks with shipping and ill know the actual temp haha
thanks!
i may not even bother with this temp sender. came across the correct part numbers for vdo gauge and sender
310-105 2 1/16 250F Elec. engine temp gauge Vision
323-095 Temperature Sender: 250F/120C - 1/8-27 NPT
50 bucks with shipping and ill know the actual temp haha
Last edited by gunsanroses91; 01-30-2014 at 11:04 PM.
#17
Did you use the v8 transmission harness? I was able to swap it over and plug strait in. And on the reverse lights you will need to find the reverse wires from the old auto shifter and connect them to the r380 reverse switch. I didn't have a wiring diagram so a lot of this is just trial and error. Same with the engine wiring. Try either green wire one will work with your cluster.
#18
#19
#20
a little update first! vdo gauge installed and engine runs at perfect temps. fuel gauge fixed by just unplugging and plugging back in. found the plug on the back of the trans and the speedo works.
made it over 500 miles on a full tank to the light on!
i couldn't get it to crank at first either and couldn't figure out why. i ended up using a new wire from the ignition straight to the starter.
made it over 500 miles on a full tank to the light on!
i couldn't get it to crank at first either and couldn't figure out why. i ended up using a new wire from the ignition straight to the starter.