Ran the scanner (Torque for Android) on my 97 today. Below is what I got back from the test results, but I am not entirely sure what it means. The sensor fail was in bank 1.

Any help is appreciated.

https://dl.dropbox.com/u/7793875/screenshot.jpg

Mode $06 report generated by Torque for Android
================================================

Vehicle VIN: Not present
Vehicle Manufacturer: Unknown
Vehicle Calibration ID: Not present

Unit and scaling information are not supplied with the data from the ECU for this type of vehicle. Consulting the manufacturers service book for this information is recommended.

Test report:
------------------
TID:$03 CID:$01
- Low sensor Voltage for switch time calculation
Max: 50
Test result value: 300
FAIL
----
TID:$04 CID:$01
- High sensor Voltage for switch time calculation
Max: 250 Min: 50
Test result value: 200
PASS
----
TID:$05 CID:$01
- Rich to Lean sensor switch time(calculated)
Min: 65,086
Test result value: 65,287
PASS
----


End of report.

 

Here is the book on the 97's ECU, and how all the codes are calculated, and their voltage values, etc. What is in the factory book does not match the values from your Android app. Maybe you's is "generic". Did you get any other codes that start with "P"?

 

Thanks.

No codes from the ECU at all. Maybe I don't have the app calibrated or setup for the vehicle correctly.

 

Rover also may use some codes differently from other vehicles.