R380 Reverse Light switch - dash gauges not working
Thread Starter
|
Winching
Joined: Aug 2009
Posts: 561
Likes: 28
From: Vancouver, B.C.
R380 Reverse Light switch - dash gauges not working
Hi,
I replaced my Reverse light switch on my Manual transmission R380 Discovery (boy was that ever a PITA!) and realized recently that I did not properly tighten it, as I finally saw where some fluid was leaking from on the driveway... traced it to the switch, and realize I may be a little low on transmission fluid now
I attempted to tighten the reverse light switch today, and ended up breaking one of the wires, so no reverse at all. Now I need to get a replacement switch yet again!
Anyways, upon going for a drive today, I quickly realized that my Speedo, RPM, and temp gauges are not registering anything! They all sit at zero... what else did I screw up today that would cause that?
Thank you
I replaced my Reverse light switch on my Manual transmission R380 Discovery (boy was that ever a PITA!) and realized recently that I did not properly tighten it, as I finally saw where some fluid was leaking from on the driveway... traced it to the switch, and realize I may be a little low on transmission fluid now
I attempted to tighten the reverse light switch today, and ended up breaking one of the wires, so no reverse at all. Now I need to get a replacement switch yet again!
Anyways, upon going for a drive today, I quickly realized that my Speedo, RPM, and temp gauges are not registering anything! They all sit at zero... what else did I screw up today that would cause that?
Thank you
Last edited by archaeology_student; Jul 16, 2014 at 04:30 PM.
Thread
Thread Starter
Forum
Replies
Last Post
ktatlow
LR4
10
Dec 21, 2020 12:19 PM
IceMagic
Discovery I
3
May 21, 2012 11:01 PM
yukonridin23
General Range Rover Discussion - Archived
6
Sep 19, 2009 11:37 AM
