Stupid clock question.
#21
10-29-2011, 09:56 PM
I replaced my digital clock with an analog, looks much better than the digital. I used only three wires, clock, light, and ground. Use a multimeter to figure out which wire is always hot=clock power. I think one of the wires came on with either the key or with the headlights, that got wired to the light bulb. Ground was black, I think. If I get a chance, I'll go pull it back out out and see what color wires went where.
Derek V
Derek V
#22
10-30-2011, 04:05 PM
Here is a few pics showing which wires go where and the tabs on the top and bottom that hold the clock in place. Feeler gauges work very well to remove the clock. Notice the top right tab is inset from the edge and not directly above the bottom right tab. It lights up and dims with the dash lights. Keeps good time and looks right for the vehicle. Very easy to adjust the time, just turn the wheel.
Derek V
Derek V
#23
10-30-2011, 04:48 PM
#24
10-30-2011, 09:22 PM
#25
10-30-2011, 09:23 PM
Winching
#26
10-30-2011, 11:11 PM
Thread
Thread Starter
Forum
Replies
Last Post
ScottinNJ
General Range Rover Discussion - Archived
0
02-21-2007 11:10 PM
