Bad Radius Arm Bushes - cracked or no?
Winching
Joined: Aug 2012
Posts: 643
Likes: 258
From: San Mateo, CA
Hopefully not the ones you picked up from me. Never noticed a clunk and they were the last thing I replaced. I had some minor clunking that went away after new shocks and springs - the first this I replaced.
Thread Starter
|
Mudding
Joined: Oct 2020
Posts: 132
Likes: 33
From: Bay Area California
Last edited by swissarmychainsaw; Jul 25, 2023 at 05:40 AM.
Thread Starter
|
Mudding
Joined: Oct 2020
Posts: 132
Likes: 33
From: Bay Area California
No the issue is this:
My radius arm and trailing arm bushing "look good" no cracks or obvious failure -- so not sure if I should replace them (I DO have new bushings in hand!)
My watts link bushes are trashed -- visibly torn rubber boots (and I'm replacing them right now) -- Going to see if this is a source of the clunking.
Replacing the three center bushes and the two outers.
My radius arm and trailing arm bushing "look good" no cracks or obvious failure -- so not sure if I should replace them (I DO have new bushings in hand!)
My watts link bushes are trashed -- visibly torn rubber boots (and I'm replacing them right now) -- Going to see if this is a source of the clunking.
Replacing the three center bushes and the two outers.
Thread
Thread Starter
Forum
Replies
Last Post