Balancing the driveshafts as a solution for vibration
#21
Or you could just balance your propshaft after rebuilding it like all driveline shops do.
I'm not sure what the aversion is to getting them balanced. Do people have the same aversion to getting tires balanced?
If you use u-joints with the zerk in the valley of the cross and orient them so they are 180 degrees apart on the DC you aren't getting maximum strength. This is explained in the propshaft sticky.
I'm not sure what the aversion is to getting them balanced. Do people have the same aversion to getting tires balanced?
If you use u-joints with the zerk in the valley of the cross and orient them so they are 180 degrees apart on the DC you aren't getting maximum strength. This is explained in the propshaft sticky.
Last edited by antichrist; 10-29-2013 at 05:48 PM.
Thread
Thread Starter
Forum
Replies
Last Post
bcolins
Discovery II
10
04-20-2014 01:29 PM
ebforce
General Tech Help
1
02-09-2012 06:10 PM