Doing connection rod bearings
TReK
Joined: May 2011
Posts: 2,768
Likes: 396
From: kitchener, canada
I am considering doing the connection rod bearings, I have a pretty good hot idle (206 deg +) tick. Does anyone know of good write or can give me an idea of how much work I am looking at. It looks pretty straight forward, except for how common is to have fit an up sized bearing.
Heavier oil and getting my cooling re-sorted will correct some of it but if I have time and it is not too bad to do on a warm summer day or 2, I can get that eliminated.
Heavier oil and getting my cooling re-sorted will correct some of it but if I have time and it is not too bad to do on a warm summer day or 2, I can get that eliminated.
maybe your liners are slipping. Get your temps fixed and maybe you will be fine
Thread Starter
|
Camel Trophy
Joined: Sep 2017
Posts: 3,818
Likes: 1,337
From: Mission BC Canada
@redwhitekat the liners were good when I did the head gaskets, and I have no tempe above 215 in the last 2.5 years.
Thread
Thread Starter
Forum
Replies
Last Post
