F$(& a centering ball.
#1
F$(& a centering ball.
Oh my god... I'd rather do head gaskets.
Damn needle bearings everywhere returning u joints and centering *****. Because I have after market driveshaft. Get it all nice and finished. (I have done plenty of driveshafts.
Not even 5 miles down the road I hear a noise turn it around and drive it as slow as possible. Make it 3/4 of the way home and off goes the driveshaft. In my rear view mirror. I know about the whole tanking out transmission. I was lucky it beat up the exhaust a little and apparently there's a small hole since i can hear it.
Go to inspect WTF happened!?
The actual drive shaft The thin part where the u joint is held in broke!
I'll NEVER do this again! I'm ordering a new driveshaft and will never touch a centering ball again.
Oh best part it felt a little smoother before it went.
Damn needle bearings everywhere returning u joints and centering *****. Because I have after market driveshaft. Get it all nice and finished. (I have done plenty of driveshafts.
Not even 5 miles down the road I hear a noise turn it around and drive it as slow as possible. Make it 3/4 of the way home and off goes the driveshaft. In my rear view mirror. I know about the whole tanking out transmission. I was lucky it beat up the exhaust a little and apparently there's a small hole since i can hear it.
Go to inspect WTF happened!?
The actual drive shaft The thin part where the u joint is held in broke!
I'll NEVER do this again! I'm ordering a new driveshaft and will never touch a centering ball again.
Oh best part it felt a little smoother before it went.
Thread
Thread Starter
Forum
Replies
Last Post