Light bulb reference for Disco 2
Light bulb reference for Disco 2
I used this as a guide for replacing my bulbs with LED, where possible. Some of them either have to have CAN-bus LED or install a resistor(6 OHM if I Recall)
http://www.sylvania.com/en-us/applic...el=656&make=53
http://www.sylvania.com/en-us/applic...el=656&make=53
Last edited by Joemamma1954; Apr 23, 2016 at 09:36 PM.
Pro Wrench
Joined: Apr 2015
Posts: 1,387
Likes: 111
From: Dallas, TX
All Joes!
Sorry, couldn't help myself. Hey Joe thanks again for the pics and having to roll around on the ground and everything. But that was all that I needed to get it wrapped-up. After all of the hours I spent laying on my back and wiping old oil sludge out of my eyeballs, I got the exact placement down and it threaded-up with 5 minutes of fidgeting.
Sorry, couldn't help myself. Hey Joe thanks again for the pics and having to roll around on the ground and everything. But that was all that I needed to get it wrapped-up. After all of the hours I spent laying on my back and wiping old oil sludge out of my eyeballs, I got the exact placement down and it threaded-up with 5 minutes of fidgeting.
Thread
Thread Starter
Forum
Replies
Last Post
Classklown90
Discovery I
4
Aug 21, 2010 07:24 PM
EstorilM
Discovery II
0
Mar 29, 2010 06:04 PM