Reverse wire under console
#11
The green and yellow (GY) wire supplies power to the switch, and a green and brown (GN) wire supplies power to the BCM, mirror and lamps when the switch is closed (vehicle in reverse). The GY wire is always hot. I tapped into the GN wire under the console at connector C0681 for my camera. I added a low amperage fuse in the line while I was at it because that circuit is protected by a 15 amp fuse which is a bit big for the light wire used by the camera.
#12
Have you looked into using wire at the Park Distance Control ECU connector? Looks like there may be a reverse only powered circuit going back there. If it'd work much easier than running another wire the whole distance.
......
Edit: Misunderstood need for circuit going to monitor for switching mode rather to power the camera only in reverse.
Glad you got it working as advertised.
......
......
Edit: Misunderstood need for circuit going to monitor for switching mode rather to power the camera only in reverse.
Glad you got it working as advertised.
......
Last edited by number9; 07-15-2016 at 01:05 PM.
#15
I tapped under the console as suggested. The green/brown wire. It was easy to run the reverse wire up to the unit that way. In the rear I used the wire right where it went into the reverse light since my camera is inside the bumper. Works flawlessly now and quite happy. Get you all some pics in a day.
#16
Thread
Thread Starter
Forum
Replies
Last Post
rezzrover
Discovery I
0
05-07-2013 06:02 PM
elboy0712
Discovery II
1
04-02-2010 11:52 AM
Evian
General Range Rover Discussion - Archived
2
05-03-2008 05:10 PM