Starts up, runs great. After 90 seconds, blinking SES P1300 and rough idle
#1
Starts up, runs great. After 90 seconds, blinking SES P1300 and rough idle
I recently put new head gaskets on my 99 Disco 128K. After the rebuild and initial debugging I have gotten to this point. I start up my Disco, it runs awesome. After 60-90 seconds the SES begins to blink and the idle speed drops below 1000 and the engine begins running rough. It spits me a P1300 engine code: Catalyst Damaging misfire, multiple cylinders Drive cycle C signal out of range (above). Besides the engine gasket set I also changed: Thermostat, air filter, plugs and wires which the parts person insisted were factory spec but after much research were revealed to be only 7mm. The truck also has a significant exhaust leak near the back box. Could it just be the wires? o2 sensor? Fuel filter? All of them? Any and all input is greatly appreciated.
Thread
Thread Starter
Forum
Replies
Last Post
95RRCLWB
Discovery I
3
06-20-2014 07:47 PM