Turns over fine - Won't Start - Intermittent
Thread Starter
|
Three Wheeling
Joined: Feb 2011
Posts: 76
Likes: 1
Got it done! Here's how I did it...
Made a trip to Harbor Freight to pick up some ramps. I was able to remove the heat cover and sensor with a small socket wrench and of course 7mm and 8mm sockets. A little tip for anyone doing this. A shallow 7mm socket would have worked better on the furthest bolt holding the heat shield on, but a normal one worked okay.
To get the connector disconnected, I amazingly was able to just use both my arms and squeeze them one on each side of the exhaust. I mean really squeeze.
Well, I'll see how it does over the next few days... Thanks for the help guys!!!
Made a trip to Harbor Freight to pick up some ramps. I was able to remove the heat cover and sensor with a small socket wrench and of course 7mm and 8mm sockets. A little tip for anyone doing this. A shallow 7mm socket would have worked better on the furthest bolt holding the heat shield on, but a normal one worked okay.
To get the connector disconnected, I amazingly was able to just use both my arms and squeeze them one on each side of the exhaust. I mean really squeeze.
Well, I'll see how it does over the next few days... Thanks for the help guys!!!
Thread
Thread Starter
Forum
Replies
Last Post
landlover_1
Off Topic
54
Jun 15, 2014 01:38 PM