I am Martinsburg WV25405

 

Close! Placerville, CA Sorry about that.

 

Well maybe if I still lived in San Diego?

 

Installed on Saturday -- above the Fog Light Switches on the Dash's left side using velcro.

Have 4 to 5 pages that cycle every 20 seconds.

Block 1 and 2 -- Top left and Right -- are always Coolant Temp and UG Voltage (car voltage)

Blocks 3 and 4 -- are other items of interest such as Instaneous MPG and Average MPG / Torque and HP / Intake Temp and Mass Airflow / etc

But purchased to get Coolant Temp with a warning alarm since my kids drive the vehicle and wanted something audible to warn them to pull over.


UK

 

I'll be honest, I didn't know it would cycle the pages automatically. Haven't really looked into all of its features yet.

 

Mine is the newest version -- Just purchased -- the only reason I figured it out was that it is hot outside so I actually read the manual first and planned it all out (page setup, what is one each page, time intervals), that is very unlike me to actually read the manual and not just power through it.

Going into the setting you will have to:
-- Turn on autopaging
-- Then for each page give it time to display, I did 20 seconds but might go faster.

This way I do not have to touch the UG while driving, just have to look at it every once in a while to gauge engine parameters

-- Do not have to touch buttons on back (buttons on front would be a huge improvement)


Great little device -- wish the LR communicated more information to it

UK

 

My page one display is : Engine Temp / Air Intake Temp
Engine Load / Throttle % Open
Timing Adv. / Mass Air Flow