Are you ready for some rebuiiiiiiild?!!!
#1
Are you ready for some rebuiiiiiiild?!!!
Sorry, I'm excited about receiving my 4 u-joints and centering bearing I ordered from Advance Auto after reading Tom's Propshaft Rebuild post.
Good ol' USA-made:
The centering ball came with a red rubber sleeve instead of the cardboard one you might have seen in the instructions:
The greased up spring in the center of the aforementioned sleeve:
Where the grease nipple will go:
The circlips that came with the u-joint (notice the "open" one - that little space is for the grease nipple):
I was a little nervous when I didn't see "neapco" on the box:
But I found it on the back of the box (sigh of relief):
Neapco is, however, prominent on the centering bearing box:
Looking forward to a fun Saturday!
I am grateful to everyone here. Just a week or so ago, I had no clue what any of this was, now - after much reading - I feel confident that I can undertake this project. Thank you. Information is power. I'll keep you all posted on the results.
Now, I'm sure I can fit under my DII without having to lift it or put it on a ramp... right?
-Anthony
Good ol' USA-made:
The centering ball came with a red rubber sleeve instead of the cardboard one you might have seen in the instructions:
The greased up spring in the center of the aforementioned sleeve:
Where the grease nipple will go:
The circlips that came with the u-joint (notice the "open" one - that little space is for the grease nipple):
I was a little nervous when I didn't see "neapco" on the box:
But I found it on the back of the box (sigh of relief):
Neapco is, however, prominent on the centering bearing box:
Looking forward to a fun Saturday!
I am grateful to everyone here. Just a week or so ago, I had no clue what any of this was, now - after much reading - I feel confident that I can undertake this project. Thank you. Information is power. I'll keep you all posted on the results.
Now, I'm sure I can fit under my DII without having to lift it or put it on a ramp... right?
-Anthony
Last edited by Antmen; 04-21-2010 at 03:54 PM.
Thread
Thread Starter
Forum
Replies
Last Post