Cross articulation error frustration
#11
Hey Abran.
I really appreciate the offer but I'm in the Eastern part of Tennessee. Would be a long drive. I was bidding on one on Ebay a couple of weeks ago and put a bid in up to $365 at the last minute and it sold for $375. Ugh!!!! Could have had it for little over $400 after transfer. I'll pick one up and just run with F26 pulled. Drove ok today and doesn't seem to lose air on any side.
I haven't had a chance to work on it today. We spent the entire day installing our new air packs in the trucks. Just now finished. I think I'll run the compressor a minute or two and let it lift from any settling then take the fuse back out and call it a day.
One question though, would bad calibration cause that right rear wheel to appear down and behind the car? Or is that more likely to be a sensor issue? That sensor is brand new.
Appreciate all the help, suggestions and advise.
Robert
I really appreciate the offer but I'm in the Eastern part of Tennessee. Would be a long drive. I was bidding on one on Ebay a couple of weeks ago and put a bid in up to $365 at the last minute and it sold for $375. Ugh!!!! Could have had it for little over $400 after transfer. I'll pick one up and just run with F26 pulled. Drove ok today and doesn't seem to lose air on any side.
I haven't had a chance to work on it today. We spent the entire day installing our new air packs in the trucks. Just now finished. I think I'll run the compressor a minute or two and let it lift from any settling then take the fuse back out and call it a day.
One question though, would bad calibration cause that right rear wheel to appear down and behind the car? Or is that more likely to be a sensor issue? That sensor is brand new.
Appreciate all the help, suggestions and advise.
Robert
#12
#13
#15
I look back at my order form and verified it was correct part ordered but have not visually put my eyes on sensor number. Will do that tomorrow when I replace end of harness plug. Connector on one end had tab broken off. This is a pic I took of new sensor. Looks correct but I will get eyes on part # it has this weekend.
Robert
Robert
#16
#17
Dakota Traveler,
That is a problem I have experienced. I generally send him an email, hear nothing for a week and resend with heading saying "2nd attempt!" Just did that this AM as a matter of fact. Very frustrating to say the least. This will make 3rd separate matter I have emailed about that I have had to do that.
Will keep you posted.
Robert
That is a problem I have experienced. I generally send him an email, hear nothing for a week and resend with heading saying "2nd attempt!" Just did that this AM as a matter of fact. Very frustrating to say the least. This will make 3rd separate matter I have emailed about that I have had to do that.
Will keep you posted.
Robert
#19
The following users liked this post:
morrisdl (06-08-2020)
#20