What did you do to your LR3 today?
So today was new front calipers, I knew one was shot and dragging. The other had a guide pin stuck so it was a rough drive. Replaced the passenger side, and took care of the pins on both the passenger and drivers side thought I was good to go, bleed the brakes and buttoned it up only to realize the drivers side caliper had froze to.....
Lucky for me I had ordered both from Lucky8 figuring I would need the other eventually. So swapped that out to. A couple hours of work and all was good on the LR3. She is stopping and going again.
Lucky for me I had ordered both from Lucky8 figuring I would need the other eventually. So swapped that out to. A couple hours of work and all was good on the LR3. She is stopping and going again.
Pro Wrench
Joined: Apr 2015
Posts: 1,620
Likes: 266
From: Melbourne, Australia.
Did a wheel rotation and found the expected cause of my clunking front end ( rear lca bush ) so adding bushes/balljoints to my timing belt kit that i'll be ordering from advanced factors this week.
