Yeah cruise is on my list, did this d2 module and it worked as long as I held the button then stopped all together again, new hoses good vacume diaphragm, brake pedal switch and several pumps that tested good, no go

 

Pulled the rear seats and carpeting out tonight. When you get right down to it there's not a whole lot to these trucks.
Look at all that room!!!

 

Do you still want the maf I sent you a pm

 

Yes! Sorry somehow I missed that PM.

 

Pulled out the TC neutral safety switch and the ghetto fab bypass switch the PO installed.


Got the Vehicle Speed Sensor 95% removed before I had to stop to go out for dinner. Will probably swap in the rebuilt one tomorrow as well as swap starters.

 

Maf going out tomorrow

 

lol that thing is pretty ghetto

 

So after I yanked the TC neutral solenoid the stupid truck wouldn't start. Not start as in not even crank. I tried a variety of things but kid's birthdays and a promotion at work and such have kept me busy. Finally did a little research and it turns out the Alarm Module gets a ground through the very solenoid I removed. I stuck a vampire clip onto the wire from Pin 1 on the smaller white plug and touched it to a bolt inside the cab. Turned the key and it fired right up!
Man that's a satisfying feeling.
Now onto more fun stuff like cutting and welding floors.

 

After seeing this pic, I'm taking my back seats out. I use this as a truck anyway.

 

whats behind this thing?