98 disco injectors have power but no pulse
#22
Crank Position Sensor (CPS or CKP sensor, not CMP cam position sensor ) is located where it can detect the flex plate down low on the left side.
It is a magnetic or hall effect type sensor. The stinger goes between a circular set of steel fingers mounted on the flex plate. Not super difficult to access from below (the heat shield is a bit of a pain), and not too expensive a part. Other threads discuss refurbing the heat shield with aluminum foil or such. I used a chunk of aluminum sheet metal and bolted it to the transmission between the sensor and the exhaust manifold.
Hope this clears things up.
It is a magnetic or hall effect type sensor. The stinger goes between a circular set of steel fingers mounted on the flex plate. Not super difficult to access from below (the heat shield is a bit of a pain), and not too expensive a part. Other threads discuss refurbing the heat shield with aluminum foil or such. I used a chunk of aluminum sheet metal and bolted it to the transmission between the sensor and the exhaust manifold.
Hope this clears things up.
Last edited by JohnZo; 04-21-2022 at 01:46 PM. Reason: sheet metal
Thread
Thread Starter
Forum
Replies
Last Post