So what did you do to your Disco today?
#3971
#3972
In the past few weeks I replaced the rear sway bar mount bushings which were missing completely, also the link bushings. Last week I changed the fuel pump as a prophylactic measure since this truck has 178000 miles on it, 174000 of which i know not the history. It was easy, the hardest part was getting the compression ferrules off the old tubes and on the new. Will be replacing other common fail items as I go along.
#3974
#3975
#3978
#3979
#3980
Saved a few bucks...
These pics will tell it all. I am to tight to spend the $70 each for new rear regulators so here is my $4.54 fix for both.
Had to shave a wee bit off with a grinding tool and drill to get into the channel after opening the end up but was minimal .
$4.54 total
the only dimension i remember is the 2 big ones are 1 inch
note the thickness difference
cut the 2 that are too small internal diameter to fit.
they will bend to get over the cap.
last, super glue the thick one that has the larger hole to the base ..
and you are done.
Had to shave a wee bit off with a grinding tool and drill to get into the channel after opening the end up but was minimal .
$4.54 total
the only dimension i remember is the 2 big ones are 1 inch
note the thickness difference
cut the 2 that are too small internal diameter to fit.
they will bend to get over the cap.
last, super glue the thick one that has the larger hole to the base ..
and you are done.
Last edited by rickroverover; 02-25-2017 at 01:21 PM. Reason: addition
The following users liked this post:
Shiftonthefly1 (03-08-2017)