I keep my RAVE iso on my hard drive and use daemon tools to run it. Never lost

 

I don't need the iso anymore, I copied the pdf file on the hard drive. Very hard to lose and if I do.... my computer can search it for me!

 

Tom,

Thanks so much, that is what I was looking for and could not find it. I appreciate it.

I think I will go ahead and try the Sears route and get a whole set of 1/4 deep well 12 point metric sockets. I did get a deep well 3/8 drive 8mm 12 point from NAPA, it fit all but the rear inner bolt on the driver's side.

I was able to snug the intake bolts down a good bit, so I cleaned everything and am waiting to see those results.

Thanks to everyone for their input, especially DiscoJag for the details from your recent efforts. That Damn harness is right in the way isn't it. I had to loosen the clamps and move it to tighten the cover bolts. What a fiasco. I wih I was a foot taller to reach over and see everything. Why did hey have to hide everything so badly?

You almost need a scaffold and walkboards to climb on to get to everything. I did rig one up when I did the plugs and wires. I wish it had a center fold hood and running boards like the 31 Chevy I recently saw.

 

Update, I tightened the valve cover gasket bolts two days ago, been monitoring the top of the water pump, so far no more oil puddling up. Hoping that was it.

 

Checked it again today, still dry after tightening, looks good so far.