Can I install an '04 SLABS unit to my '02 without CDL?
#1
Can I install an '04 SLABS unit to my '02 without CDL?
So I don't have the t-case ready yet, but I want to make sure the SLABS unit I have is working and not programmed for SLS (if so, hoping my Lynx can re-program it)
Is there any issue with swapping it in now and not hooking up the CDL wires?
Is there any issue with swapping it in now and not hooking up the CDL wires?
#2
The following users liked this post:
Jeff Blake (09-13-2017)
#5
In other news, I am starting the '04 transfer case rebuild tomorrow. 1.41 hi-gear, new input gear, HD cross pin, and various other little bits arrived today from Ashcroft. Hoping this will fix my sluggish hill climbs. And of course, CDL I plan to make a video of the teardown and rebuild and post it here. Though I said the same about the engine, and never did it.
#6
#7
#8
Yes!! It's gonna happen. I want it as much for my own reference... nothing worse than putting something back together and forgetting where the long bolt went...
I was lucky enough to get a free transfer case from Abran (thanks to UPS damaging it during shipment, good news is Abran is getting paid too) so I've been practicing the tear down on that. Punching out bearings, races, etc. It's a different beast than the engine for sure... requires more muscle... and lots of new tools.
I was lucky enough to get a free transfer case from Abran (thanks to UPS damaging it during shipment, good news is Abran is getting paid too) so I've been practicing the tear down on that. Punching out bearings, races, etc. It's a different beast than the engine for sure... requires more muscle... and lots of new tools.
#9
#10