Diagnostic tools... best bang for the buck
#31
03-16-2020, 08:38 PM
This has the whiff of a scam. New member. Four posts total, all today offering to sell a Nanocom for $75. Red flags galore.
The following users liked this post:
glopez2k (07-10-2020)
#34
03-25-2020, 07:15 AM
Recovery Vehicle
Sure, and that Nanocom is sitting in my Discovery now. Erica was fantastic at providing the information I requested, and shipped the same day.
The following users liked this post:
glopez2k (07-10-2020)
#36
06-04-2020, 02:59 PM
Don't bank on the Fuxwell, it's not very intuitive nor can I do everything I need to on different vehicles, i.e. it does all the basic stuff and some extras but not everything, for everything. Not to mention, you have to buy the software for each vehicle for around 50 bux each after the initial free one. Then again, I'm not very intuitive either, you'll probably have better luck!
#37
06-04-2020, 04:34 PM
Camel Trophy
@dparham ... Are you sure your OBD port wiring is good? Have you tried another diagnostic tester to verify it could be bad?
Sad to hear the NT530 isn’t up to par like the 510 or 520.
I use my NT510 more in my wife’s 2011 BMW X5 than my Disco 2 since I also have a Nanocom for it.
Sad to hear the NT530 isn’t up to par like the 510 or 520.
I use my NT510 more in my wife’s 2011 BMW X5 than my Disco 2 since I also have a Nanocom for it.
Last edited by JUKE179r; 06-04-2020 at 04:37 PM.
#38
06-06-2020, 10:28 AM
Hi Juke, i have the RWS Amigo and it works and clears amigos and codes... so Im assuming that the foxwell NT530 was either not functioning properly or needs unavailable updates... could not auto Vin or manual but could manually enter the screens but could not power bleed or communicate with SLABS... i HAD an 00070 SLABS unit.. bought another used guaranteed unit from a supplier off ebay with 100% and tons of landy sales so assuming it worked but got the exact same messeges.. no communications with SLABS but my RWS Amigos worked.. again perfectly clearing any codes... ironically the :22 gnd fault went away also... maybe due to new slabs but Im assuming i need program the new slabs or make some changes like if it had ACE or other things...... at this moment I returned the NT530 and considering a nanocom...
#39
06-28-2020, 01:20 AM
@dparham ... Are you sure your OBD port wiring is good? Have you tried another diagnostic tester to verify it could be bad?
Sad to hear the NT530 isn’t up to par like the 510 or 520.
I use my NT510 more in my wife’s 2011 BMW X5 than my Disco 2 since I also have a Nanocom for it.
Sad to hear the NT530 isn’t up to par like the 510 or 520.
I use my NT510 more in my wife’s 2011 BMW X5 than my Disco 2 since I also have a Nanocom for it.
Thread
Thread Starter
Forum
Replies
Last Post