DII Cruise Control
#41
The blue circle shows where the final end of the linkage attaches to the cruis control actuator. That "L" bracket is held in place to the rubber actuator by 2 plastic pieces. That's where mine broke. Have you checked the actual cable by the throttle body to make sure the springs and all are still ok?
The following users liked this post:
JUKE179r (01-27-2017)
#43
Thanks for the update AZRover.
So I buttoned it back up and I've located the CC brain. Per this thread:
https://landroverforums.com/forum/di...rol-fix-26617/
I'm going to give it a try with the meter to see if I get anywhere.
So where I am:
- Suck test on the plenum- PASS
- general hose condition (hold a vacuum)- PASS
- Actuator motor- PASS
- Light on the switch- PASS
- Throttle body linkage and such- PASS
I think this leaves me to the diagnostic process of the brain per the above unless someone has a better suggestion. Thanks a bunch for all the input.
So I buttoned it back up and I've located the CC brain. Per this thread:
https://landroverforums.com/forum/di...rol-fix-26617/
I'm going to give it a try with the meter to see if I get anywhere.
So where I am:
- Suck test on the plenum- PASS
- general hose condition (hold a vacuum)- PASS
- Actuator motor- PASS
- Light on the switch- PASS
- Throttle body linkage and such- PASS
I think this leaves me to the diagnostic process of the brain per the above unless someone has a better suggestion. Thanks a bunch for all the input.
#45
My thoughts were that everything seems in good shape on the motor and such and the seals were good, etc., so I'm making an assumption that they are OK.
I think I'll do the electrical checks detailed in that other post- at least the ones checking for juice on specific terminals when various switches in various conditions are activated. If that checks out, then I'll go back to the vacuum exercise. It takes only a couple minutes to remove the pump, so not a big deal.
One thing I didn't mention was that I do have the 3 amigos on right now and when I had the full on Rover codes pulled, there is a possible wheel speed sensor bad. I read in other threads that the 3 amigos as not related, but as the speed comes from the SLABS, which feeds a couple places based on the manual, could that be a source? If so, after the electrical checks, I may hold off until "option B" is completed and go from there.
Last edited by longtallsally; 01-26-2017 at 08:35 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Evan5291
Discovery II
10
11-21-2017 07:59 AM
southfloridadiscoII
Discovery II
22
06-28-2009 11:03 PM