Knock Sensor - Replacement Part Question
#11
See attached page from Bosch tech manual. Basically, the ECU monitors the sensors for a voltage produced by the engine at all times. The ECU filters the signal looking for that knock signal ( a higher level), but it also wants to know that the "microphone" is still plugged in. If it is low the code in created, could indicate bad sensor, disconnected or shorted wire, corrosion on plug, etc.
#13
#17
Follow the link, find the right electrical dwg for your vehicle and check wiring continuity.
Good luck.
Franky
Land Rover Manuals
Good luck.
Franky
Land Rover Manuals
#18
Here's the drawing, you'll need to disconect sensor, (which you did, no change in code, so we know we are on the correct side of the engine) - and a plug on the ECU. You would be looking for any short at any ohm level between the black and the pink with stripe (black or white - depends on side). Also read both wires for any short to ground (frame of truck, don't stick meter lead in the dirt..lol).
#19
Finally got around to dealing with this. Actually, I attempted NJ inspection (after clearing the code), but failed due to the pending code. Oh well. Now, I HAVE to repair it.
This brings me back to the thread. I have a multimeter, but am a complete novice. Savannah, I have a general understanding of your instruction, but let's back up on step. What settings should I have set on the multimeter? Also, at which points should I test the wiring? I'm assuming at the connection to the sensor and then back at the ECU in the passenger footwell. Correct?
This brings me back to the thread. I have a multimeter, but am a complete novice. Savannah, I have a general understanding of your instruction, but let's back up on step. What settings should I have set on the multimeter? Also, at which points should I test the wiring? I'm assuming at the connection to the sensor and then back at the ECU in the passenger footwell. Correct?