Progress on my HG job
#11
Im getting to that part right now with my project. While I guess fresh in your memory, how hard was it to remove all those head bolts? Im getting there, almost, but cant remove those head bolt with the 16mm. Been trying half day already but it wont move a bit. Im even afraid if theres a tool that can reach the bolt near the firewall. Any advice?
1/2-inch drive, 24"+ break over bar
a 3/4-inch drive 2-3 foot long with a pipe for leverage will turn anything loose, you just have to get the proper socket and flexible extensions
Last edited by chubbs878; 11-08-2016 at 09:42 PM.
#13
#15
#16
#17
#19
Yea I had some leaks from my front cover and water pump so I went ahead and did all the bits.
Question for those familiar with the heads. I called a recommended machine shop, for the pair its going to be $110 to have them cleaned and decked. It would be another $85 for the valve job. Is the valve job something recommended to be done with experience or if I've gotten this far could I do it?
Question for those familiar with the heads. I called a recommended machine shop, for the pair its going to be $110 to have them cleaned and decked. It would be another $85 for the valve job. Is the valve job something recommended to be done with experience or if I've gotten this far could I do it?