What did you do with your DII today?
#6011
The following users liked this post:
Sixpack577 (10-17-2018)
#6012
#6013
#6014
These engines seem like they are luck of the draw with what you get.
The idiots at the machine shop would put in the freeze plugs without sealant(3 of them leak, and the engine never started), managed to put a big knick about the 6 o'clock position on the freeze plug edge, on the one on the left side of the back of the block(among their other screw ups).
I haven't decided if if it can be tig welded and smoothed, or if it's totally fecked. Regardless, it doesn't inspire confidence in this engine.
#6015
I just want a dependable V8 in it.
These engines seem like they are luck of the draw with what you get.
The idiots at the machine shop would put in the freeze plugs without sealant(3 of them leak, and the engine never started), managed to put a big knick about the 6 o'clock position on the freeze plug edge, on the one on the left side of the back of the block(among their other screw ups).
I haven't decided if if it can be tig welded and smoothed, or if it's totally fecked. Regardless, it doesn't inspire confidence in this engine.
These engines seem like they are luck of the draw with what you get.
The idiots at the machine shop would put in the freeze plugs without sealant(3 of them leak, and the engine never started), managed to put a big knick about the 6 o'clock position on the freeze plug edge, on the one on the left side of the back of the block(among their other screw ups).
I haven't decided if if it can be tig welded and smoothed, or if it's totally fecked. Regardless, it doesn't inspire confidence in this engine.
#6017
#6019
Mailday! @oslo_d2 received Britpart taillamp gaurds, Trasharoo bag 60" Hi-Lift and tool kit. I made a quick prototype mount to see what I thought of putting it up front on the brushgaurd. I had it on the bottom tube first, but it was too low and interfered with approach angle. Where it is in the picture is good, but not sure if I like it. It is functional, but not great.
Any other recommendations on Hi-Lift mount locations?