Attempted to replace my rear wheel hub last night but broke my breaker bar LOL. Need to order a high torque impact and a new bar then I'll try again during the next break from rain. That or I'm going to my friends shop to use their high torque air impact this weekend.

 

Harbor freight 3/4" drive ratchet set, 4 foot cheater. Works at relatively low cost compared to impact. I broke a 1/2 drive husky socket before I bought my set.

 

Finally got around to ordering some new tires to mount on my old American Racing Baja wheels for the '03. I went with a set of Kenda Klever AT2's in 265/75r16 to go with the 2" lift. Now I'll have to either clean and polish the wheels to give them back their shiny silver finish or get some wheel paint to spray them black in the spring.

 

Got some fresh powder!

 

Nice! We’ve had a lot of that this year as well. Big White (British Columbia) is a 35 minute drive from my house. It’s usually the P38 that we take instead of the Disco as I’ve got the studded tires on it.

 

crankshaft position sensor finally repaired. Managed to get it on and off without taking off the down pipe of the exhaust. The connector was difficult not knowing there was a bracket holding it in place. Only could fit one hand barley in the area to perform the job. 7 mm for the cover, 8 mm and spacers is all it took

 

 

how much ?

 

Installed a rear cargo shelf from Flat Dog UK the other day. It was a pain in the butt since the included template to mark the holes was WAY off. Next up is getting my 270º awning brackets modified to work with my rack. Then some much needed touch up paint on the rack itself.

 

Been thinking about ordering that shelf as well. How's the quality feel and the install process other than the template being way off. Also what was off about it in case I order one too LOL