Window regulator issue....need advise
#11
#12
I have done regulators twice in the last two weeks. (different ones) both had died wile in the "UP" position, there are four screws to that you remove and two that remain and are keyed in the door, I removed all four and the regulator lowered to the bottom of the door at that point I was able to access the two bolts that hold the window to the regulator at that point I used masking tape to hold the window in place. one was the FR regulator and the other RR was the window motor, but I also found the regulator was binding a little too. If its stuck in the raised position the key is to remove all four screws.
The following users liked this post:
GCBurke (01-11-2019)
#13
I just did a thread on the driver side regulator replacement and the optimal solution. First remove all four of the regulator frame bolts; then begin to ease the entire regulator to the bottom; stopping long enough to disconnect the motor wiring harness as it passes the little round hole. Then remove the two bolts that hold the window to the regulator frame. Once the window has been released from the frame lift the window back to the top and hold it in place with a couple of screwdriver handles; then you can freely manipulate the regulator in the bottom of the door.
doc
doc
The following users liked this post:
GCBurke (01-20-2019)
#14
#15
#16
YES! You'll be doing it again soon too.
Thread
Thread Starter
Forum
Replies
Last Post