Centering Ball help..almost done
Thread Starter
|
Three Wheeling
Joined: May 2009
Posts: 61
Likes: 0
From: White House, Tn
Centering Ball help..almost done
Im in the middle of the front driveshaft rebuild and ran into an issue.
New centering ball kit is in but the (dust shield/metal cap with rubber gasket in the middle) will not stay in. Precision 617 is the kit I went with. Any tip/tricks on making this seal stay in? Hopfully everything with the install is correct so far. Just can't make it stay. Thanks for any help. I'm taking a break and going to bed.
New centering ball kit is in but the (dust shield/metal cap with rubber gasket in the middle) will not stay in. Precision 617 is the kit I went with. Any tip/tricks on making this seal stay in? Hopfully everything with the install is correct so far. Just can't make it stay. Thanks for any help. I'm taking a break and going to bed.
Thread
Thread Starter
Forum
Replies
Last Post
