Hi, brand new member so excuse the immediate question.
I have a UK spec D2 TD5 with 145k on the clock. I have just replaced the transfer box and when I went to start it after the work it would not turn over.
Battery is good (I put it on chsrge to make sure). I'm getting full electrics but when turn the ignition key all I get is a faint click from the relays in the engine bay fuse box. Starter solenoid doesn't click. The only other sound is occasionally the suspension compressor kicking in for a second or two.

Went back under to double check the sensors on the transfer box (reverse light switch and neutral sensor) both seem fine.

Any suggestions on why it won' turn over? I don't have a fault code reader unfortunately.

Thanks in advance.

 

Did you press the inertia switch on the firewall?