trying to replace idler pulleys
Thread Starter
|
Drifting
Joined: Apr 2013
Posts: 39
Likes: 0
From: tulsa,ok
trying to replace idler pulleys
I am trying to replace both idler pullys on my 2000 land rover disco II,
but its not going well for me.I cannot get the bolts to budge, ive used 13mm socket with a breaker bar,ive used 13 mm box and open end wrench
nada.nothing,no movement,
what am i doing wrong!
any advice your willing to give would be appreciated
but its not going well for me.I cannot get the bolts to budge, ive used 13mm socket with a breaker bar,ive used 13 mm box and open end wrench
nada.nothing,no movement,
what am i doing wrong!
any advice your willing to give would be appreciated
Mudding
Joined: Jul 2012
Posts: 107
Likes: 4
From: Las Vegas, NV
I recently did mine too and had similar issues. All I can say is try to soak them with a penetrant and let it soak overnight. If you can't get it loose with a wrench don't try to pry it off otherwise you will definitely break something. The new WD 40 rust release seams to work good. I used it on all my exhaust bolts and didn't break a single one. Be sure to soak the heck out of it and let it sit for a while.
Thread
Thread Starter
Forum
Replies
Last Post
