Power steering
#1
Power steering
Hey. Today I replaced my power steering pump everything went pretty good. But when I started my car I got a HDC fault(the one with the triangle with the arrow around it). Does anyone know why this would happen?
alsoI had to boost my car to get it started because I left the battery on the cold cement floor all day and it drained(because I'm a dummy).
Its a 2008 lr2 with the 3.2l
thanks
alsoI had to boost my car to get it started because I left the battery on the cold cement floor all day and it drained(because I'm a dummy).
Its a 2008 lr2 with the 3.2l
thanks
#2
Do a hard reset.
1. disconnect battery
2. fully charge battery
3. touch disconnected positive and negative leads together for 30 minutes to remove any residual charge
The various modules in the LR2 become very unhappy if the voltage gets below 10 volts (even briefly while starting the engine)
Good Luck
Paul
1. disconnect battery
2. fully charge battery
3. touch disconnected positive and negative leads together for 30 minutes to remove any residual charge
The various modules in the LR2 become very unhappy if the voltage gets below 10 volts (even briefly while starting the engine)
Good Luck
Paul
Thread
Thread Starter
Forum
Replies
Last Post
johnnyjohnny
Discovery II
15
09-26-2019 09:37 PM
DiscoBritney
Discovery I
16
12-19-2011 06:24 PM
losinov
Retired - Private For Sale/Trade Classifieds
0
03-21-2011 08:57 PM
jycsalas
General Range Rover Discussion - Archived
1
04-17-2009 02:21 AM