I am about to order the OME 751/762 & HD springs for my 01 D2. I have been searching thru the forum and found a lot of dead links for any tutorials for spring replacement. Does anyone know if a link that still works?

Basically I think the only specialty tool needed is a spring comressor, correct?

Mark

 

Mark, will you be running a front bumper and winch, if not, the 751 will cause the front end to be higher then the rear. If no bumper I would suggest a 779 front coil.
I can walk you thru the installation, check out the LRRF site for a good price.

 

OK. I will look into the 779's instead. I did have plans to eventually install a winch bumper, but don't have the cash for that modification right now since I also need tires, water pump, hoses, O2 sensors, etc....that I will be doing at the same time as the suspension. Thanks Mike.

 

If you are going for a bumper, go for the 751's and just sit a little taller till the rest of your work is done, save having to changes the coils again later.

 

Hey mike. Please post the step by step suspension installation. Maybe some will benefit if you post it. Thanks in advance.




______________
If you ain't first your last!
battery charge

 

I don't have one but can walk anyone thru it if needed.