My ‘59 Series II 88 has no fan on the water pump but a pusher fan. This set up isn’t optimal, and now the switched fan has stopped working. NOT GOOD.

Dumb questions:

Where is the fuse box on a Series II?
Could it be that the dash switch has gone bad?
I believe this truck has a Series III engine in it.
Do I add a fan to the existing water pump, new radiator?
there is no fan shroud.
Temps are going/showing past 190 degrees.

Help?

 

My ‘63 2A had the fan on the water pump. I don’t think your setup is normal. The fuse panel (on mine) was in the engine compartment, on the RH side of the firewall. Only 2 fuses for the whole vehicle.

 

I would go on the roversnorth website and get yourself a proper cooling system. Order the fan shroud etc and put it back to stock