What did you do with your DII today?
#5111
#5112
The following users liked this post:
Sixpack577 (04-12-2018)
#5115
I swapped out all of the oils and fluids (minus brake because it will be swapped when a new master cylinder comes in), and installed a metal front bumper yesterday afternoon. I would have never sprung for an ARB new, but this one was a CL special for $550 that came with new crush cans and mounting hardware. Just needed a little rust removal and un-denting!
#5117
#5118
It's a lot easier to simply replace the caliper. Go on rockauto. After the core exchange, a reman caliper is only like 35 bucks
#5119
#5120
Did a lot of tinkering on Myrtle today...
I finally fixed my OBD2 port that was pushed out of it’s mount hole. https://landroverforums.com/forum/di...14/#post643807
While I was working under the steering wheel I installed a Duralast brake switch #LU410
New brake switch and old brake switch
Installed new Bosch MAF #0280217532, a new Bosch throttle switch #0280122016, and a Smittybilt aluminum winch shackle #2820.
I also replaced my Fram FV237 PCV for the FV308 PCV.
I finally fixed my OBD2 port that was pushed out of it’s mount hole. https://landroverforums.com/forum/di...14/#post643807
While I was working under the steering wheel I installed a Duralast brake switch #LU410
New brake switch and old brake switch
Installed new Bosch MAF #0280217532, a new Bosch throttle switch #0280122016, and a Smittybilt aluminum winch shackle #2820.
I also replaced my Fram FV237 PCV for the FV308 PCV.
Last edited by JUKE179r; 04-12-2018 at 12:25 PM.