I hate you....

but yeah I hope so

 

FYI new pullies were just what I needed.

 

Looking good, I m sure you are like me, if it sits too long with no movement start to drive you nuts

 

Tom we have a lot in common.

Ok so got the motor back out. Cut the firewall, installed the new column and fought the rack into position.

I think I'm in trouble closing this up.












It's going to shift about an eighth of an inch closer to the fire wall but that's about it.

 

Nice!

 

Use poster board or light card board & masking tape to create the patch desired, that's how I'd do it.

 

Just got back from the store, I was out picking up poster board. Ok and some Junior mints because they looked good at the checkout lol

 

lol......I buy it all the time, never got a funny look, even when I grabbed purple...

 

Noticed that I don't quite have the rack aligned properly something shifted and it's binding just a bit crooked so I'm trying to sort that out. . Got about half my pieces cut from the templates. I bought a air nibbler to cut steel that thing is awesome!! So much easier and faster.





Also had a pm asking about belt alignment so here that is




Saw this when I went to Sears had to take a pic so I could share....

 

Wow clown car , sorry I never get the point of giant rims