Camber/ alignment problem
#11
I forgot about the bolt Pattern on the flanges... Been a couple years since ive had my ball off... Married with two kids
Is there any play in the pins or the bearings? Wheel off the ground, rock the wheel with hands at 12 and 6 oclock is the pin check and 3 & 9 is bearing check... you probably already knew and checked that.
Is there any play in the pins or the bearings? Wheel off the ground, rock the wheel with hands at 12 and 6 oclock is the pin check and 3 & 9 is bearing check... you probably already knew and checked that.
I'm gonna tear it apart, inspect everything, put the stub axle back on the right way this time( flat facing up), and take it to have the alignment checked. If indeed the camber is that far off, I'll just swap the entire housing off my parts car. I was trying to avoid that being how much time and money I had into rebuilding and re-sealing my current one.
Thread
Thread Starter
Forum
Replies
Last Post
Waggy23
General Range Rover Discussion - Archived
0
05-16-2007 10:00 PM
jomeheretu11
General Range Rover Discussion - Archived
3
10-31-2005 06:55 AM