Power lose mid throttle P1316
Mudding
Joined: Aug 2012
Posts: 167
Likes: 2
From: Alpharetta Georgia
I just had similar issue with my 97'. My wires on the Knock sensor and Crankshaft sensor were touching due to beat down by oil, heat and whatever else. I cut about 10" up the wire to open it up and electrical taped the wires apart. Cranked up and ran smoothly 1st time in a while. Might want to just check those 2 things closely.
Thread Starter
|
Mudding
Joined: May 2009
Posts: 121
Likes: 0
From: Arlington TN
Three Wheeling
Joined: Nov 2018
Posts: 70
Likes: 0
Was just wondering if yours was running similarly to mine. I replaced the fuel filter to know avail and will be replacing the gas cap with the proper vented unit. However, per my other thread the truck has a more serious issue, that is most likely related to this. I'll come back when I have a solution. Let me know if you figure yours out in the mean time.
Thread Starter
|
Mudding
Joined: May 2009
Posts: 121
Likes: 0
From: Arlington TN
Problem solved! So, the o2 sensors I ordered came in today. I installed them this afternoon and ....... it still ran the same. Horrible. It had a clutch job some time recently before I bought it. And the wiring going to the o2 sensors seamed out of wack. I was able to find a wiring diagram with colors going to the sensors and discovers that they were all plugged into the wrong plugs. Now it runs like a new truck. So at least in this whole process I stopped the fuel pressure bleeding off problem. And it may or may not have needed the o2 sensors to run correctly but probably was due anyways.
Winching
Joined: Feb 2010
Posts: 554
Likes: 59
From: Burlington, NC
Problem solved! So, the o2 sensors I ordered came in today. I installed them this afternoon and ....... it still ran the same. Horrible. It had a clutch job some time recently before I bought it. And the wiring going to the o2 sensors seamed out of wack. I was able to find a wiring diagram with colors going to the sensors and discovers that they were all plugged into the wrong plugs. Now it runs like a new truck. So at least in this whole process I stopped the fuel pressure bleeding off problem. And it may or may not have needed the o2 sensors to run correctly but probably was due anyways.
glad you found the solution.
Thread Starter
|
Mudding
Joined: May 2009
Posts: 121
Likes: 0
From: Arlington TN
Thread
Thread Starter
Forum
Replies
Last Post
bcolins
Discovery II
20
Jun 21, 2011 08:06 AM
