Can you elaborate?

 

I run Procomp 16x8 with 4.25" backspacing with 285/75s

 

In South Africa sold as "Safari"
Very strong canvas and washable.

 

Join the club!!!!!! (Lol)

 

Finally got a excuse to go for those 33's
And got my front propshaft back and hope it will accommodate the huge angel.

 

That driveshaft is interesting. I hope it works out for you but with your lift(about 4" if I recall correctly) I'm not sure the geometry will jive. I thought the D1 front geometry from the factory could almost accommodate a Double Cardan shaft but for $ reasons they went with some out of phase set up. Lifting a D1 3"+ almost always necessitates a DC shaft, since the pinion ends up pointing at the TC and the TC output is at zero.

 

well wife took the rover to drop off son and could not get driver window up, I could only get it to move slightly, it was stuck, took it al apart and could not find a problem reinstalled reg and works fine I have no clue

I keep seeing that 13.5 volts is what the alt is supposed to put out I barely get over 12 so found i am missing grounds under hood so I added a ground from batt to rad support now it seems good at 13.6+ will be adding more later

 

I got this via UPS! I felt like a kid on xmas morning.

 

Presents in the mail! The best...

 

Had the windows tinted today, after removing the old tint. Looks much nicer now.