New Tactical 4x4 (Rovers) custom front bumper:



I preferred their bumper over the competition except for a few points so I suggested some revisions. After much communication, Kep and Eric thankfully agreed to custom fabricate it outside of their normal laser cut workflow. I'm very happy with how it turned out

 

Looks much more serious than the Rotella doorstop.

 

Looks great! Is that a stock Saudi grille or a custom fab? Liking the hood pins as well.

 

That's some great memory you have there Buzz!

Grill is genuine, but this isn't a very flattering shot. Truck is filthy.

 

Installed my snorkel (ARB/Safari Snorkel SS390HF), but ran into a fitment issue. Looks like the MAF sensor bumps up right against (and displaces the oil dipstick medially). Anyone else run into this? Is the MAF installed correctly?


Finished. Took a pathetic 5 hours. May need to re-evaluate how much time I'm going to need to change out my oil cooler lines.

 

I installed an OME 2 inch lift and a wilderness rack

 

keoni flip your MAF around 180 so the plug is facing towards the fender

 

Thanks Jake!

 

A few more..

 

Lookin good! Possibly a dumb question: did you have to disable/remove the hood latch in the cabin to install the hood pins?