Stock switch wiring advice
#11
#12
#14
#15
Correct. The stock Volume Up/Down buttons closed ground. I cut those two wires and one is power in to the switch and the other is power out to the relay.
I'm about to use the stock FOG light switch to control a Rigid Dually reverse/work light in the back. I'll be using a relay for that as well.
I'm about to use the stock FOG light switch to control a Rigid Dually reverse/work light in the back. I'll be using a relay for that as well.
#16
#17
Yes because the bodies are the same shape and they'll all basically fit in eachother's spots.
No for two reasons.
1) There are tabs on the switch bodies and not all will line up with eachother. This can be remedied by cutting off the tab that doesn't line up with a razor knife.
2) The switches at the top and bottom of the instrument surround have extra plastic molding for finishing.
#18
Thread
Thread Starter
Forum
Replies
Last Post
LandRoverChic
Retired - Private For Sale/Trade Classifieds
0
11-11-2014 04:54 AM
DiscoSux
Retired - Private For Sale/Trade Classifieds
0
11-17-2010 09:46 PM