Trouble lights
OK.. My ABS and SRS lights are on constantly.. AND the Right hand side of the SRS light is blinking...Horn works...
ABS light stays on all the time and I've tried jumpering 5 & 15 on the connector to get a blink code.. Nothing...
NO Check Engine light ever.. I'm assuming it's burned out or has been pulled..
So, I'm looking for input on troubleshooting... A relay missing or fuse on the ABS ?
What about the SRS.. Strange that the right hand side is flashing...
Thanks for any help anyone can offer... I'm just really getting started on these issues so I'm looking for tips..
Thanks
John
ABS light stays on all the time and I've tried jumpering 5 & 15 on the connector to get a blink code.. Nothing...
NO Check Engine light ever.. I'm assuming it's burned out or has been pulled..
So, I'm looking for input on troubleshooting... A relay missing or fuse on the ABS ?
What about the SRS.. Strange that the right hand side is flashing...
Thanks for any help anyone can offer... I'm just really getting started on these issues so I'm looking for tips..
Thanks
John
From RAVE -
and
So this means those lights come on by command of a module, not a plain switch to ground, like oil pressure. See page 123 and 127 of 556 pages of the 1996 D1 electrical circuits guide, in the RAVE. There are dual indicators in the SRS light. Your off the shelf code scanner will not read the ABS or the SRS modules, will need a dealer level or very advanced shop unit.
ABS Warning Light
The ABS warning light receives battery voltage with
the Ignition Switch (X134) in position II. It is
grounded by the Anti–Lock Brake System ECU
(Z108) or the ABS Warning Relay (K103) in the
event of an ABS problem.the Ignition Switch (X134) in position II. It is
grounded by the Anti–Lock Brake System ECU
(Z108) or the ABS Warning Relay (K103) in the
and
SRS Indicators
The SRS Indicators are controlled by the Air Bag
Diagnostic Control Module (Z151) and the SRS
Indicator Control Circuit of the Instrument Cluster
(Z142) to indicate SRS System faults.Diagnostic Control Module (Z151) and the SRS
Indicator Control Circuit of the Instrument Cluster
So this means those lights come on by command of a module, not a plain switch to ground, like oil pressure. See page 123 and 127 of 556 pages of the 1996 D1 electrical circuits guide, in the RAVE. There are dual indicators in the SRS light. Your off the shelf code scanner will not read the ABS or the SRS modules, will need a dealer level or very advanced shop unit.
Thread
Thread Starter
Forum
Replies
Last Post
01d2Jeff
Discovery II
10
Nov 19, 2011 10:52 AM
drakenkade
Discovery II
5
Dec 19, 2010 01:28 AM



