Coolant loss but none when pressure tested
#21
#22
Shop around! Get a second, third and fourth opinion as long as it is driving and not overheating.
Actually I would run from that place. Something sounds fishy.
$2200 is around the going rate for a HG job with the heads being machined and valve job included.
Actually I would run from that place. Something sounds fishy.
$2200 is around the going rate for a HG job with the heads being machined and valve job included.
Last edited by Dave03S; 11-03-2015 at 05:45 PM.
#23
#24
The Will Tillery route mentioned sounds like a good plan too, because I've heard the heads he sends have been machined well and look amazing.
If I had a D2 that needed an engine, and I wanted "like new" condition, I'd buy a turner short block like Julian did, and a set of Will's cylinder heads.
The following users liked this post:
CollieRover (11-05-2015)
Thread
Thread Starter
Forum
Replies
Last Post
austinlandroverbill
Discovery II
5
05-28-2015 05:57 AM